| Chassis |
1U, rack-mount Front—power and HA status LEDs, physical system reset pinhole, console and local storage interfaces Rear - One network interface unit slot (signaling, media and management interfaces),
- Single or dual AC or DC power supplies, field-replaceable fan packs
Optional mounting brackets for front/rear or center-mount in 19” or 23” rack |
| Memory |
2 GB RAM for active configuration and operation 256 MB internal flash memory |
Content addressable memory (CAM) local storage |
128K entries for static & dynamic ACLs, media control rules and ARP entries Optional 500 GB storage expansion module for local CDR backup |
| Encryption options |
TLS - Software-based encryption for low capacity TLS sessions
- Secure Services Module (SSM) hardware accelerator option for high capacity TLS sessions
SRTP - Network Interface Unit (NIU)-based encryption processors
IPsec - Tunnel set-up—software-based for use of manual keys; Secure Services Module (SSM) hardware accelerator option for use of dynamic keys
- Traffic encryption—NIU-based encryption processors
|
| Network interface unit (NIU) |
Service network interface options for signaling, media and data
Basic NIUs and options
- Four 10/100/1000 Mbps Ethernet copper ports (RJ-45 connector)
- Four 1000 Mbps Ethernet fiber or four 10/100/1000 Mbps copper ports (requires SFP transceivers)
- Four 1000 Mbps Ethernet fiber or four 10/100/1000 Mbps copper ports with inline IPsec/SRTP encryption processors (requires SFP transceivers)
- Four 1000 Mbps Ethernet fiber or four 10/100/1000 Mbps copper ports with inline QoS measurement processors (requires SFP transceivers)
- Four 1000 Mbps Ethernet fiber or four 10/100/1000 Mbps copper ports with inline IPsec/SRTP encryption and QoS measurement processors (requires SFP transceivers)
Transcoding NIU
- Four 1000 Mbps Ethernet fiber or four 10/100/1000 Mbps copper ports (requires SFP transceivers)
- Up to twelve on-board transcoding digital signal processor (DSP) modules
- Inline QoS measurement processors
Enhanced Traffic Control NIU
- Four 1000 Mbps Ethernet fiber or four 10/100/1000 Mbps copper ports (requires SFP transceivers)
- Integrated high-capacity encryption (IPsec, SRTP, TLS) processors
- Inline QoS measurement
- Integrated hardware-based SIP-TLS and TCP processing
NIU management interfaces—included on all NIU options - Two 10/100/1000 Mbps interfaces with RJ-45 for HA node configurations
- One 10/100/1000 Mbps interface with IPsec encryption processor and RJ-45 for management networks
(Optional IPsec encryption of management interface via encryption capable NIU) - One RS-232 serial console interface with RJ-45 connector (only rear or front interface may be used at any time)
- One alarm interface with RJ-45 connector
|
| Front panel management interfaces |
One RS-232 serial console interface with RJ-45 connector (only rear or front interface may be used at any time) One USB 2.0 interface LEDs for displaying power and HA status Physical system reset pinhole |
| Power |
|
| AC option |
Voltage: Autoranging 100-240 VAC wide input with power factor correction Frequency: 50/60 Hz Current: 3A x 2 rating Cable: 2.0 meter 18 AWG 3-wire cable, with 3-lead IEC-320 receptacle on the power supply end, and a country-dependent plug on the power source end
|
| -48 VDC option |
Voltage: -48 VDC (+- 10%) nominal in North America. Maximum range is -40VDC to -60 VDC Current: 7A x 2 rating Cable: 18 AWG recommended minimum, with at least 3 conductors rated for at least 140° F (60° C)
|
| -72 VDC option |
Voltage: -72 VDC nominal in Russia Cable: 18 AWG recommended minimum, with at least 3 conductors rated for at least 140° F (60° C)
|
| Physical |
|
| Dimensions |
1.72 in H x 17.10 in W x 19.00 in D (not including mounting hardware) 4.37 cm H x 43.43 cm W x 48.26 cm D (not including mounting hardware) |
| Weight |
19 lbs (8.62 kg) fully configured |
| Colors |
Front panel—Midnight black with Glacier blue trim |
| Temperature |
Operating: 32ºF to 104ºF, 0ºC to +40 ºC Storage: -4ºF to 149ºF, -20ºC to +65 ºC |
| Relative humidity |
10 to 85%, non-condensing |
| Air flow |
50 cfm front to back |
| Heat dissipation |
100W (341 BTU/hour) typical, 200W (682 BTU/hour) maximum |
| Power dissipation |
100W typical, 200W maximum |
| Regulatory |
Product bears CE1 marking indicating compliance with the 99/5/EC directive, which includes EN and IEC standards for safety and EMI |
| Safety |
US: USA/CSA UL2 60950-1, 1st Ed. Canada: CAN/CSA3-C22.2 No. 60950-1-03, 1st Ed. EU: EN4 60950-1:2001 |
| EMI |
US: FCC5 Part 15 (CFR 47) Class A limits Canada: ICES6-003 Issue 4, Class A limits EU: EN55 22:2006 +A1:2007 Class A limits Australia: CISPR 22 and C-Tick Japan: VCCI7 Class A |
| Immunity |
EU: EN 300 386 v1.3.3 |
NEBS
|
GR-63 GR-1089 SR-3580—Level 3 |
Security |
U.S. FIPS 140-2 compliant U.S. DISA security mitigations for EBC (Edge Border Controller)
|
| |
|